7.0 Printer
1.
Make sure the printer is properly connected and powered on.
2.
Run the printer self-test.
If the
printer self-test does not run correctly, the problem is in the
printer.
Refer to the printer service manual.
If the printer self-test runs correctly, install a wrap plug on the
parallel port and run the advanced diagnostics tests to determine which
FRU failed.
If the advanced diagnostic tests (with the wrap plug installed) do not
detect a failure, replace the printer cable.
problem, replace the system board.
IBM PS/2 Model N51 SX HMS
Printer
If that does not correct the
¦ Copyright IBM Corp. 1991
7.0 - 1