How To Use This Manual - IBM SYSTEM/36 5362 Setting Up

Each step that you perform is identified with two
numbers. The first number identifies the section and the
second number identifies the step within that section.
•••
I
When you complete a step, go to the next step .
•••
-
-
---------------------------------------------------~
-
• •
"'tJi-----~---------------------------------------
Some steps will ask you questions. Depending on how you
answer the question, you might not always go to the next
step, as shown in the example.
Are the display stations and printers set up and checked out?
EXAMPLE ONLY
YES
NO
- -
- -
-
-
-
-
-
-
-
-
.- ..
How to Use This Manual
Sometimes you might need additional information to
complete a step. Always read the information in the step first
and then the additional information .
..
Additional Information for 1 . 3 ,
Are the display stations and printers set up and checked out? Sometimes this manual Will use the words
work
statIon
Work
statIon
means either a
printer or display station
A symbol that appears like
i
is pointing toward
a nother step.
This means go to Section 3, step 2.
An arrow l i k e " is used to point out or locate
something on the art.
A broken arrow like
II.I~
is used to show action such
as push, pUll, turn, go to, and so on.
A small hand like
pressing action.
is used to show location and a
Note: To avoid problems during setup, you should follow the
instructions in this manual step-by-step. If you encounter a
problem, instructions outside the steps tell you what to do.
How to Use This Manual ix