Removing A 9332 Disk Unit(S) - IBM SYSTEM/36 5362 Setting Up

REMOVING A 9332 DISK UNIT(S)
This section takes you through the steps necessary to remove a
9332 Disk Unit(s) from your computer.
The steps
must
be done in the indicated order:
1 . Save the information that is now on the 9332 Disk Unit(s).
2. Delete the information from the 9332 Disk Unit(s).
3. Run the configure-customize program to delete the 9332
Disk Unit from the disk configuration.
Only one drive can be deleted from the configuration at a
time.
4. Physically remove the 9332 Disk Unit from the computer.
Repeat steps 1 through 4 to remove a second drive.
-
-
-
~--------------------------------------------------------------.,
158
-
T
9332 Disk Units are removed one at a time starting at the end
of the logical chain. The end of the logical chain is the 9332
Disk Unit with the terminator installed.
To remove a 9332 Disk Unit that is not at the end of the logical
chain (a drive #0), you must remove drive #1, remove drive #0,
then reinstall drive #1 (making it the new drive #0).
Only previously configured-customized disk units can be
removed.
Go to
&II .