B3. Installing The Divus Touchzone - Divus TZ07-B?TZ07-W Technical Manual

TZ07-B, TZ07-W
Note: Warranty regulations
DIVUS guarantees for DIVUS TOUCHZONE a warranty of 24 months after shipment (valid from
date of delivery) if not stated otherwise. The warranty is only valid if all transportation takes place
with the original package, including all shock absorbing elements, of the product.
Every repair shipment has to be approved by the technical support. Contact us under support @ divus.biz.
On that occasion you also get all necessary information, as well as the accompanying letter "repair request".
The original packaging has to be used for all transportations, as well for the one back to the distributor or
manufacturer (like for repair). Otherwise DIVUS can't give any guarantee for the product. Any damage
occurring to the product if incorrectly packed will be charged to the client. Furthermore in such a case DIVUS
will charge an additional fee for packing.
For repair processes the document "repair request" has to be compiled and returned with the product to
allow us to guarantee an efficient service and a two week repair time.
For technical reasons only complete products can be returned to reparation.

B3. Installing the DIVUS TOUCHZONE

Installing wall mount kit
The wall mount box may be installed in a cut out in the wall, in a wooden structure thick at least 1,5 cm or in
a dry mortarless construction. The cut out has to respect the sizes specified in the technical data and has to
be at least 8 cm deep.
In the wall cut out, the box can become build in while it can be screwed on in a piece of furniture. It is
important that the fore edge of the wall mount kit is flat and horizontally to the surface of the wall or the
piece of furniture.
The wall mount kit offers cable access at all four sides.
Installing TZ
Switch off the system/plant supply voltage. Connect the power and controlling cables. After the correct
cabling and connecting the magnet, the TZ is put into the wall mount box and is fixed with the screw
included in the packing. Now, you can install your design frame with slight, even pressure.
Caution!
Unauthorized changes or modifications to the TZ configuration may result in permanent damage to
the system or its functionality. Only authorized trained personnel are allowed to make any
modifications.
Caution!
If you need to remove the design frame, extract it from the mounting horizontally. One-sided
traction or slanted installing can damage the frame.
Caution!
In order to be able to dissipate the warmth produced by the equipment, it must be guaranteed, that
the temperature within the mounting box does not exceed 45°C. Under normal conditions this is
given with an ambient temperature of up to 30°C. If these values are exceeded, additional cooling
has to be provided.
The equipment must be installed vertically, i.e. the front plate must be in an angle of 90° to the base
plate.
E-10