Installing The Divus Touchzone - Divus TOUCHZONE TZ07 User Manual

DIVUS TOUCHZONE .
16
Every repair shipment has to be approved by the technical support. Contact us under support@divus.eu. On that
occasion you also get all necessary information, as well as the accompanying letter "repair request".
The original packaging has to be used for all transportations, including the one back to the distributor or
manufacturer in case of arantee for the product. Any damage occurring
to the product if incorrectly packed will be charged to the client. Furthermore in such a case DIVUS will charge
an additional fee for packing.
document has to be compiled and returned with the product to allow
us to guarantee an efficient service and a two week repair time.
For technical reasons only complete products can be returned for repair.
2.3

INSTALLING THE DIVUS TOUCHZONE

Installing wall mount kit
The wall mount box may be installed in a cut out in the wall, in a wooden structure thick at least 1.5 cm or in a
drywall construction. The cut out has to respect the sizes specified in the technical data and has to be at least 8
cm deep.
In the wall cut out, the box can be built in or it can be screwed on in a piece of furniture. It is important that the
fore edge of the wall mount kit is flat and horizontally to the surface of the wall or the piece of furniture.
The wall mount kit offers cable access on all four sides.
Installing TZ
Switch off the system/plant supply voltage. Connect the power and controlling cables. After connecting the
magnet to the back of the mount box, the TZ is put into the wall mount box and is fixed with the screws included
in the packing. Now, you can install your design frame with slight, even pressure.
ATTENTION! Unauthorized changes or modifications to the TZ configuration may result in permanent damage to
the system or its functionality. Only authorized trained personnel are allowed to make any modifications.
ATTENTION! If you need to remove the design frame, extract it from the mounting horizontally. One-sided traction
or slanted installing may damage the frame.
ATTENTION! In order to be able to dissipate the warmth produced by the equipment, it must be guaranteed that
the temperature within the mounting box does not exceed 45°C. Under normal conditions this is given with an
ambient temperature of up to 30°C. If these values are exceeded, additional cooling has to be provided.
The equipment must be installed vertically, i.e. the front plate must be in an angle of 90° to the base plate.
Installation has to comply to HD 60364-4-41 or other national prescriptions.