B3. Installing The Divus Touchzone - Divus TOUCHZONE TZ07 User Manual

DIVUS TOUCHZONE . 10

B3. INSTALLING THE DIVUS TOUCHZONE

INSTALLING WALL MOUNT KIT
The wall mount box may be installed in a cut out in the wall, in a wooden structure thick at least 1.5 cm or in a
dry mortarless construction. The cut out has to respect the sizes specified in the technical data and has to be
at least 8 cm deep.
In the wall cut out, the box can become build in while it can be screwed on in a piece of furniture. It is
important that the fore edge of the wall mount kit is flat and horizontally to the surface of the wall or the
piece of furniture.
The wall mount kit offers cable access at all four sides.
INSTALLING TZ
Switch off the system/plant supply voltage. Connect the power and controlling cables. After the correct
cabling and connecting the magnet, the TZ is put into the wall mount box and is fixed with the screws
included in the packing. Now, you can install your design frame with slight, even pressure.
Caution! Unauthorized changes or modifications to the TZ configuration may result in permanent damage to
the system or its functionality.
Only authorized trained personnel are allowed to make any modifications.
Caution! If you need to remove the design frame, extract it from the mounting horizontally. One-sided
traction or slanted installing can damage the frame.
Caution! In order to be able to dissipate the warmth produced by the equipment, it must be guaranteed, that
the temperature within the mounting box does not exceed 45°C. Under normal conditions this is given with an
ambient temperature of up to 30°C. If these values are exceeded, additional cooling has to be provided.
The equipment must be installed vertically, i.e. the front plate must be in an angle of 90° to the base
plate. Installation has to be conform to HD 60364-4-41 or other national prescriptions.