Divus TZ07-B?TZ07-W Technical Manual page 33

TZ07-B, TZ07-W
Even the selection popup of the external units can be scrolled vertically and contains further entries (not
shown in the screenshot above). For example the list contains the entry „Manual Config.", which permits the
integration of external units, whose type is not directly defined by an entry in the selection popup. In this
case, beneath the fields already described on the previous page, also the following 4 entries will be shown for
the external unit:
- DTMF - Accept:
- DTMF – dooropener:
- DTMF - Hangup:
- DTMF - auxiliary (optional):
When selecting another type from the selection popup, above fields are automatically filled in correctly (and
therefore are not shown at all); only in case of the manual configuration they have to be inserted.
Furthermore, when using the manual configuration, the IP address of the camera must be inserted as full
path to the motion-jpeg stream of the camera instead of only using the bare IP address.
Note: please give special attention to the allocation of the VoIP IDs of the external units: only if the
external unit effectively uses the VoIP ID, for which the configurations have been made, the camera
signal and the DTMF tones will be assigned correctly. Please also note that the IDs are already
preconfigured (901-910, corresponds to DIVUS standard for VoIP systems); for example, if you
want to configure the external unit 910, please use the external unit 10 and don't just rename the
external unit 1 from 901 to 910. The same applies for the internal units, which according to the
DIVUS standard are pre-configured from 101 to 120.
Once the external units are configured at wish, the changes can be saved by clicking on the text block on top
of the page, as already mentioned before.
DTMF tone for starting the conversation
DTMF tone to control the door opener, is connected to the KEY-
icon in the app
DTMF tone for closing the conversation
DTMF tone to control the auxiliary relay, is connected to the LIGHT-
icon in the app
E-31