Divus TZ07-B?TZ07-W Technical Manual page 28

TZ07-B, TZ07-W
Enable remote access
Remote IP Address
Remote Port
Username
Password
Refresh Cache
Password Protection
The „Back" entry will take you back to the main screen of the web app. If parameters of the web app have
been changed within the settings menu, the connection will be refreshed automatically.
Note:
The switching between local and remote access is not required when using the app on DIVUS TZ,
since it will always run in the local network. If the app instead is installed on mobile devices, the
mentioned checkbox is required to determine if the device is currently connected in the local
network (and should therefore use the local settings) or if it is connected through the mobile
network (and should therefore use the remote settings).
When starting the app for the first time an advice will be shown that no server has been configured yet. The
use of the app will only be possible if at least the IP address of the targeted KNXSERVER is inserted. When
leaving the settings page after modifying this value, the app will try to connect to the specified server. During
this procedure a loading screen will be shown, which will be substituted by the home page of the server as
soon it is loaded completely:
This checkbox enables the remote access function of the app. If it is enabled, the
local settings are ignored and the remote settings for IP address and port will be
used, so that the app can connect to KNXSERVER through the mobile network
(requires that an appropriate port forwarding for KNXSERVER has been
configured; further information about this topic can be found in the
INSTALLATION MANUAL of KNXSERVER.
IP address or domain name used for the remote access to KNXSERVER (normally
the public IP address of the router with the active port forwarding to
KNXSERVER).
External port of the router, which is redirected to port 443 of KNXSERVER (for
remote access, only SSL-protected connections are allowed).
This value refers to the user name the app should use to login to KNXSERVER.
This user name must be present in the configuration of the server and dispose of
the necessary permissions to access the visualisation. If this criterion is fulfilled,
the user name can be inserted in this field and – in combination with the
password in the next setting – will cause the app to automatically login to the
server. If this field is left empty, the app will show an extra login window, where
the authentication to the server has to take place.
The password which is required – in combination with the user name explained
above – in order to correctly login to the server.
If this menu entry is clicked, the local cache of DIVUS TZ is emptied / deleted and
at the next connection to the server all necessary data is downloaded again from
the server. This function is necessary whenever changes are made on the server
side (like for example change of the theme, creation of new rooms etc.). In these
cases the cache has to be refreshed before DIVUS TZ will show the new
configurations.
As already mentioned, this point allows defining a password which protects the
access to the settings menu. If this field is left empty, access to the settings is
granted to everybody clicking on the settings button.
E-26