Divus TZ07-B?TZ07-W Technical Manual page 22

TZ07-B, TZ07-W
The menu „Display Settings" is another link to a standard settings menu of Android and beneath the
configuration of the display timeout (used for the display dim and off functions) also permits to manually
change the brightness of the display of DIVUS TZ. Furthermore animations (like for example when changing
between apps) can be disabled, what saves performance and lowers the energy consumption of the device.
The setting „Show navigation bar" permits to enable / disable the navigation bar in the lower area of the
screen. At delivery the navigation bar is always enabled.
The next menu entry is called „Brightness Control" and is only enabled if for the „Power Management" the
option „Display always on" has been selected. In this case it is possible to configure an automatic brightness
control in dependency of the integrated brightness sensor. The configuration of the brightness control is
done through the following menu:
It is not necessary to use all 3 dimming steps; if a step should be ignored, simply set a Lux value that never
will be reached.
Since the measured brightness value in Lux strongly depends on the mounting type and position, it is
recommended to configure the brightness control only after the mounting of the TZ.
E-20
The checkbox permits to enable /
disable the control.
The currently measured Lux value
is very important for a correct
configuration of the control and is
used to establish the current
ambient brightness.
The 3 dimming steps permit to
create different
thresholds. Each dimming step
works in the same way; if the Lux
value in the input field on the left
is trespassed, the brightness will
be set to the value of the
corresponding slider.
When changing the slider values,
the display brightness will be
actively changed, in order to give
you a preview of the brightness
value that should be set.
brightness