Divus TZ07-B?TZ07-W Technical Manual page 32

TZ07-B, TZ07-W
The menu entry „Phonebook" opens a sub menu that permits to configure up to 10 external units and 20
internal units. On top of the sub menu a drop down menu permits to switch between external and internal
units; furthermore, a help button that informs about the parameters to be set in this page and a back button
(that also works as saving button) are present. The area below those buttons can be scrolled vertically and
gives access to each of the external / internal units.
Every external unit shows the following parameters:
- Type:
- VoIP ID:
- Display name:
- Ringtone:
- Main camera - IP:
- Add. camera – path:
- QuickDial button:
The internal units instead will show the following parameters:
- VoIP ID:
- Display name:
- QuickDial button:
- Image file:
- Ringtone:
The screenshots on the following page show the configuration sub menu of the external units as well as the
selection popup of the type of the external unit:
The type of the external unit can be selected through a selection popup
This value must match the VoIP-ID (username) of the external unit,
as configured within the VoIP server
Optionally a display name can be specified, which is shown in the status bar
during incoming calls of the corresponding number (overwrites eventual
values sent by the VoIP server)
Optionally a separated ringtone can be selected, which will be played
at incoming calls of the selected external unit
In this field the IP address of the camera of the external unit, which should
be shown automatically during an incoming call, has to be inserted
Optionally the path of a 2. Video signal (either image- or video-path) can be
specified. In the main window it will then be possible to change between
main and additional camera using horizontal swipe gesture
If this checkbox is enabled, the dial window (check out page 11) will show a
corresponding QuickDial button with the VoIP ID (or the display name, if
previously configured), which permits to call the external unit directly
This value must match the VoIP-ID (username) of the internal unit,
as configured within the VoIP server
Optionally a display name can be specified, which is shown in the status bar
during incoming calls of the corresponding number (overwrites eventual
values sent by the VoIP server)
If this checkbox is enabled, the dial window (check out page 11) will show a
corresponding QuickDial button with the VoIP ID (or the display name, if
previously configured), which permits to call the internal unit directly
Optionally a picture can be defined, which will be shown at incoming calls of
the selected internal unit; it is possible either to select a local picture file or
to specify the URL of an image in the world wide web
Optionally a separated ringtone can be selected, which will be played
at incoming calls of the selected internal unit
E-30