Divus TZ07-B?TZ07-W Technical Manual page 19

TZ07-B, TZ07-W
The next entry deals with the network settings of DIVUS TZ:
DIVUS TZ supports as well the use of a static IP address as also the usage of DHCP. Depending on your
network, these parameters must be configured correctly in order to connect DIVUS TZ with your network and
also with the internet (check out the screenshot in the middle, which shows the configuration menu for the
LAN port). If you are unsure about the correct configuration, please refer to your network administrator.
Furthermore this menu in the last version supports also the configuration of the optional Wi-Fi module
offered by DIVUS. If this module is connected to TZ, the menu will automatically show an additional entry
"Wi-Fi" and you will be able to switch between the different connections (Ethernet and Wi-Fi). A parallel
usage of both interfaces is not supported. After enabling the Wi-Fi port, a click on "Network configuration"
will not point to the menu shown above in the middle, but will open the default Android Wi-Fi settings page
(check out screenshot on the upper right).
In the last version of the Launcher-App, this menu will also show the current IP address of DIVUS TZ.
Note: When the connection has been established correctly, in the upper right corner of this
configuration page a green symbol showing 2 PCs will be shown. Only when this symbol is active,
the DIVUS TZ is correctly connected to your network.
The next 2 settings refer to the control of the RGB-LED of DIVUS TZ. The first option permits to use the blue
LED as orientation LED. When the checkbox is enabled, the LED will be continuously on and can be seen as
operating LED or as orientation LED by night.
The second option instead handles the control of the red LED and uses it to signal the current network state.
If DIVUS TZ is not connected to a network and the checkbox of this option is enabled, the red LED will be
turned on. As soon as the device connects to the network, the LED will turn off. Therefore, the option
„Network-Check LED" acts in the same way as the symbol of the network connection described in the note
above. Naturally, by disabling the corresponding checkbox, also this functionality can be disabled.
E-17