3. Changing the deflection
When changing the installation method for the projector from ceiling mounting to floor mounting or rear mounting.
you will need to switch over the deflection changeover connectors which
are
connected to the H printed circuit
board and V printed circuit board.
These printed circuit boards can be seen when the projector cover is opened.
Refer to the illustration below
when switching over
the connectors.
CAUTION:
.
Be sure
to
turn off the main power
supply
before
switching over
the connectors.
.
It the connectors
are not fully inserted.
or if 'hAY are
inserted in the wrong
place, it might
cause problems with
"",,V.
UtA:>
COOtfOl
~
~
';?~ft.:~(.. .-:{.:
55 -
-
~ ~ ~ ~ ~ ~ ~