22. ZONE
(Zone convergence) button
This button is used to switch to zone convergence adjustment mode for correcting
partial color misalignments.
. Setting is possible once the TEST button has been pressed so that a test pattern is
displayed on the screen.
.
Zone convergence adjustment should be carried out only after all other convergence
adjustments (SIZE. UN. SKEW. BOW. KEYSTONE, KEYSTONE BALANCE, PIN,
PIN BALANCE, CENTERING) have been completed.
Button operation procedure
~
;~ @
~~ <> tV'
j\~
\V
.
Be sure to press the STORE
button
twice to register the
changes
after
zone
convergence adjustment is
completed.
. The area affected and the way that the convergence changes are different tor each zone number. Refer to the
'00.
'
'-_M~'~""
e~
8-
Use the "+" and "-" control buttons
to move the cursor to the zone (21
locations shown in the illustration
above)
to be adjusted.