Table of Contents
Advertisement
~~E::J
~DB
Immmi
8888
81
"N.'.I~~$ro:.o~I:=1
9. Control buttons
These buttons are used to select the adjustment
mode and to set the adjustment
levels
([
in each adjustment mode.
'+'
.
If these buttons are pressed during blanking adjustment, the adjustment mode
'.::D
selection function is activated.
e
.
If these buttons are pressed during zone convergence adjustment, the cursor is
moved around on the screen. (Zones 1-21)
!
. If these buttons are pressed in a picture adjustment mode.
level adjustment can be
carried
out. (BRIGHT, CONTRAST, COLOR, TINT, SHARPNESS)
10. A rrow buttons
These buttons are used to adjust the setting levels
in each
adjustment mode.
@
.
These buttons can be operated when characters are being displayed on the screen
':61
In an adjustment mode.
@) V' @
.
The settings can be
changed
within a range of 0-255. The minimum
setting value is
@
displayed as MIN and the maximum setting value is displayed as MAX. (MIN, 1, 2.
3...253. 254. MAX)
I
I
. After
the adjustment mode has been selected, pressing these buttons has the
foliowinQ
effect.
When
the
button is pressed, the item is adjusted upward.
When the
button is pressed. the item is adjusted downward.
When the
button is pressed. the item is adjusted to the right.
When the
button is pressed, the item Is adjusted to the left.
NOTE:
.
In raster adjustment mode. the characters
displayed
on the screen
will
be cleared approximately 10 seconds
after the button
is
released. and the adjustment mode will be cleared.
.
The convergence changes for each
arrow
button are different for each convergence mode. Refer to the
following
pages
for details.
~ ~ ~ ~
- 73-
Advertisement
Table of Contents
