Changing The Input Signal; Using The Auto Setup Feature - Panasonic PT-LC50U Operating Instructions Manual

Changing the input signal
The input source for picture signals can be changed by pressing the INPUT
Buttons on the projector operating panel or on the remote control unit.
YPBPA
VIDEO
The signal from the source which is
connected to the RGB/YPBPR connector is
projected.
This terminal accepts input of RGB input
signals from a personal computer and DTV
Format signals (RGB, YPBPR) from a DVD
or a digital broadcast. No monitor or
projector can automatically decide whether
a Component signal is the RGB-type or the
YPBPR-type. So, you will have to select
either RGB or YPBPR manually.
The signal from the source which is
connected to the S-VIDEO IN connector or —
VIDEO IN connector is projected.
lf cables are connected to both connectors,
the S-VIDEO signal will be selected
automatically. (The S-VIDEO signal has
priority.)
Using the Auto Setup Feature
When projecting RGB signal images from a personal computer, it is possible to
automatically adjust the image's position, dot clock and phase simultaneously
(only for projection of images with RGB signal inputs other than DTV format
signals). Perform the operation described below if you wish to use this function.
Press the AUTO SETUP Button on the remote
control unit.
10
Auto Setup