CD
Loosen the five screws shown in the illustration, and then slide the
plate out to remove it.
illustration.
Then remove the four
screws
shown in the
. Adjusting the static focus
<Focus control positions>
G) Press the TEST button on the remote control so that the
crosshatch pattern is displayed on the screen.
@ Cover the lenses which are not being adjusted with the lens
caps.
CID
Turn the focus control inside the focus control block (shown
in the illustration at right} which corresponds to the lens being
adjusted until the image comes into focus.
~ ~ ~
(2) lift
up the printed circuit board.
Loosen
Focus control block
58 -