Table of Contents
Advertisement
Buttons
that can be used in service mode
~
This button is used
to turn the power
supply for the projector Dn Dr tD Ihe
stand-by
mode.
Input selector buttons
-'-'-"-"'--'
'-"'",-
These buttons are used to select the
~
source for input signals received by the
proj ector.
RASTER SIZE
button
This button is used
to adjust the height and
width of the picture on the screen.
control operation mode between normal
operation mode and service mode. (If you
want to switch to seNice mode. set Ihe
service mode switch inside the battery
compartment to "ON".)
This butlon
is used to adjust the position 01
the center of the picture.
This button
is used to register dala such as
convergence adjustment data.
Three modes
can be registered for each
'"
different type of signal.
/
White balance adjustment mode buttons -.----
These bullons are used to switch to white
balance adjustmenl mode.
~
RGB buttons
These buttons are used
to select the
color
ror adjustment
In convergence
adjustment
mode and other modes.
"'
"" , 1 .
"
.."'.,
This button is used to switch the
color temperature setting belween
LOW, MID and HIGH.
~ ~ ~ ~ ~
Advertisement
Table of Contents
