Table of Contents
Advertisement
4. RASTER
SIZE button
NOTE:
. After
pressing
this button
to switch to adjustment mode, the setting values can be adjusted by pressing the
arrow buttons.
.
The
screen display will
toggle between the crosshatch pattern and the crosshair pattern each time the TEST
button
is pressed. However. make this adjustment using an external input signal.
NOTE:
. The setting
can be changed within
a range of 0-255. The minimum setting value is displayed as MIN and the
maximum setting value is displayed as MAX.
. The
characters
displayed on the screen
will be cleared approximately 10 seconds after
the button is released.
.
If the horizontal scanning frequency for the input signals is within the range of 15-29.17 kHz. the right
edge of
~
\
r;;Go'"1 1...n:A 1 I".'."
~
""
UN
GOlcur""'1
Immmi
1I0TO.On
~
p."."11
lONE I
r-;;u11.,NeA.
I ~f«T.N~
.,,"~
L...::::..J
"'ANt'
S
[
I"",",srl -
~
~
@@
@
This button is used
to switch to the mode for adjusting the
height and width of the picture image.
.
€s~
@
Tt
@......... The vertical amplitude becomes narrower.
.
r:;@~
\@r, ((8)
~~y
@.........
(0......... The horizontal amplitude becomes wider.
Advertisement
Table of Contents
