Table of Contents
Advertisement
20. PIN BALANCE
button
This
button
is used to switch to dynamic convergence adjustment mode for adjusting
the balance for the pin cushion distortion of the red (R), green (G) and blue (B) picture
segments.
.
SettIng is possible once the TEST
button
has been pressed so that a test pattern is
displayed on the screen.
NOTE:
. If proper pin cushion distortion adjustment is not possible because the pin cushion balance is so poor, use this
adjustment to correct the pin cushion distortion
balance.
Button operation procedure
Adjustment of pin cushion distortion balance
for the green segment:
.
..- '.'~'.
" ,.-)
NOTE:
.
If you would like to clear the adjustment
settings,
turn off the power for the projector without pressing the
STORE button. The adjusted settings cannot be
cleared once
the STORE button has been pressed twice.
.
The procedures for adjusting the blue and red pin balance are the
same
as that for the green pin balance given
above.
~ ~
~
~
e
~e
---
~
6
@@
@
~
W;-J
)~
~.)
~ ~ ~ ~
Advertisement
Table of Contents
