Table of Contents
Advertisement
(Green)
(§) While referring to the table below, adjust the positions
of the CRTs to the indication that matches
the desired
projection screen size. (The brackets which hold the CRTs are marked with numbers as shown in the
illustration above.) Once the position of a CRT has been determined, secure the CRT by tightening the CRT
mounting screws.
Furthermore, install the correct spacers to match the
size of the screen. Select the spacers
by referring
to the table below.
Front
side
(7) Install the lenses
in their original positions. and then
secure them with the twelve fens mounting screws.
NOTE:
. Make sure the correct lens is installed to the
correct CRT. Check the lens color by referring to
the color of the label which
;s attached
to the lens.
A silver label is attached blue
(8) lens.
.
Install the lenses so that the focus adjustment
screws are facing upward.
(~) Install the front grille. and then
tighten it
with
the six
screws.
(~ Install the X-ray cover, and then tighten it with the four
sr.rAWS.
1.0,.
Close the cover.
NOTE:
.
After carrying out this adjustment. the convergence will
be
greatly changed.
so it should also be adjusted.
Back side
The letter "B" appears on the reverse side of the
R spacer.
1;
Install
the
spacers
while
making
sure
that
the
arrow
positions
and colors are correct.
-
~
~
51
-
~
Advertisement
Table of Contents
