Connecting To A Wireless Access Point; Searching For Wireless Access Points To Set Up A Connection - Panasonic HC-X1 Operating Instructions Manual

≥ When [DIRECT] is selected, [SECURITY TYPE] is fixed to [WPA2-AES].
≥ Some settings in [BAND], [CHANNEL (2.4GHz)] and [CHANNEL (5GHz)] cannot be selected
depending on the wireless module used.
≥ For details on how to enter characters, refer to page 144.
3
Touch [RETURN].
4
Set [DHCP] to [SERVER].
MENU
: [NETWORK SETUP] # [Wireless LAN setup] # [DHCP] # [SERVER]
5
Touch [EXIT].
6
Select the SSID of this unit from the Wi-Fi
7
Enter the password into the iPad.
8
Check the network connection.
≥ When this unit is ready to be connected,
≥ To terminate the connection, after terminating the connection on the iPad side, set [USB MODE]
to [OFF].

Connecting to a wireless access point

Configure the settings in this section to connect this unit and an iPad using a wireless access point.

∫ Searching for wireless access points to set up a connection

≥ Attach a wireless module that support this unit to the USB HOST terminal of this unit.
(l 142)
≥ Set [USB MODE SELECT] to [HOST].
≥ Set [USB MODE] to [ON].
1
Select the menu.
MENU
: [NETWORK SETUP] # [WIRELESS SETUP] # [SSID(SELECT)]
2
Touch the wireless access point to connect to.
≥ The SSIDs of wireless access points found with the search will be displayed.
≥ If you touch [Refresh], you can search for wireless access points again.
3
Touch [ENTER].
≥ If an encryption key (password) is not set, the setup is complete.
4
(If an encryption key (password) is set)
Enter the password.
≥ For details on how to enter characters, refer to page 144.
≥ When the connection is complete, touch [Enter].
5
Check the network connection.
≥ When the connection is complete,
≥ To terminate the connection, after terminating the connection on the iPad side, set [USB MODE]
to [OFF].
will be displayed on its screen.
(l 197)
(l 197)
is displayed on the screen of this unit.
- 147 -
®
setup of the iPad.