Table of Contents
Advertisement
[PRE-REC]
≥ Register [PRE-REC] to a USER button.
This allows the recording of an image and audio to start before you press the recording start/stop
button. AVCHD scenes will be recorded from approximately 3 seconds before the operation, while
MOV/MP4 will be recorded from approximately 4 seconds before the operation.
≥ [P-] is displayed on the screen. After you start recording, the display changes to [P-REC].
≥ Aim the unit at the subject beforehand.
≥ There is no beep sound.
≥ This function is not available in the following cases:
j During Super Slow Recording
j In Variable Frame Rate Mode
j When [2 SLOTS FUNC.] is set to [BACKGROUND]
j During the Interval Recording
≥ In the following cases, a 3 second image that precedes the recording of an AVCHD scene or a
4 second scene that precedes the recording of an MOV/MP4 scene may not be recorded:
j Immediately after the maximum PRE-REC standby time has elapsed*
j If the length of time from when [PRE-REC] is set to [ON] to when you start recording is too short
j If the length of time from when you display the recording screen by turning it off and on or pressing
the THUMBNAIL button to when you start recording is too short since you set PRE-REC
j When the card slot selected for motion picture recording is switched automatically because you
started recording with normal settings or when [2 SLOTS FUNC.] is set to [RELAY REC]
* The maximum PRE-REC standby time is 3 hours. Once PRE-REC is activated, it is automatically
deactivated and then re-activated every 3 hours.
≥ Images displayed on the thumbnail in Playback Mode will differ from the motion pictures
displayed at the start of playback.
[WFM]
≥ Register [WFM] to a USER button.
This function displays waveforms on the LCD monitor.
Press USER button in the recording screen.
≥ When [WFM TYPE] is set to [WAVE] or [VECTOR], each press of the button enables/disables
WFM.
≥ When [WFM TYPE] is set to [WAVE/VECTOR], each press of the button switches the setting.
WAVE (wave display) # VECTOR (vector display) # OFF
≥ If you have enabled WFM by touching the applicable USER button icon, set [WFM] to [OFF] to
disable it.
(l
173)
≥ This function is not available in the following cases:
j When using the viewfinder
j When recording yourself
j When using Focus Assist
≥ [WFM] will be canceled in the following cases:
j If you turn the unit off
j If you press the THUMBNAIL button
j When [USB MODE SELECT] is set to [DEVICE] and this unit is connected to a PC.
(l
82)
(l
103)
(l
100)
(l
182)
(l
82)
(l
37)
(l
56)
- 95 -
(l
177)
j During Freeze Frame
j When color bars are displayed.
(l
41)
(l
89)
(l
106)
(l
133)
Advertisement
Table of Contents
