Panasonic HC-X1 Operating Instructions Manual page 58

∫ To change the peaking settings
If you set Focus Assist to ON by following either of the
procedures below, in-focus portions are highlighted with
color (peaking).
j Setting the menu item [FOCUS ASSIST 1] to
[PEAKING] or [BOTH] and pressing the FOCUS
ASSIST button or the USER button to which [FOCUS ASSIST 1] is registered.
j Setting the menu item [FOCUS ASSIST 2] to [PEAKING] and pressing the USER button to
which [FOCUS ASSIST 2] is registered.
: Peaking
G
≥ You can set the peaking color and strength.
(When changing the peaking color)
Select the menu.
MENU
: [SW SETUP] # [PEAKING COLOUR] # desired color
[Red]/[Blue]/[Yellow]/[White]
(When setting the peaking strength)
1 Select the menu.
MENU
: [SW SETUP] # [PEAKING LEVEL] # desired setting
2 Touch /
≥ You can select a value between s7 and r7.
3 Touch [EXIT] to complete the setting.
(Notes on Focus Assist)
≥ Focus Assist is not possible in following cases:
j During Recording Check
j During Freeze Frame
j When color bars are displayed
≥ Focus Assist is canceled in following cases:
j If you turn the unit off
j (If you operate the FOCUS ASSIST button or the USER button to which [FOCUS ASSIST 1] is
registered)
When the setting of [FOCUS ASSIST 1]
j (If you operate the USER button to which [FOCUS ASSIST 2] is registered)
When the setting of [FOCUS ASSIST 2]
j When you set this unit to Auto Focus
j When you press the USER button to which [FOCUS TRANS] is registered or touch the
applicable USER button icon
≥ The magnified display and peaking are not displayed on recorded images.
≥ The magnified display and peaking are not displayed on an external monitor.
≥ Freeze Frame is not available when you use Focus Assist.
to adjust settings.
(l 88)
(l 89)
(l 106)
(l 61)
(l 56) is changed
(l 56) is changed
(l 89)
- 58 -
