SX1 K1 am-en, A31008-H6500-A5-1-7619 (29. July 2003, 19:32)
80
Connection
You need access points to
access the Internet for example to
• send/receive e-mails (p. 38)
• send/receive multimedia
messages (p. 37)
• use WAP applications (p. 51)
• activate modem operation
To connect to an access point, a data
connection is needed. There may be
access points predefined by your
provider. Otherwise your provider
will provide you with further
information on this.
C
KSetupKSettingsKConnection
KSelect a function:
Access points
A list of default or defined access
points may be shown. Select an
access point from the list or define a
new one.
Note
You may receive the settings in a smart
message. If you save them, the received
settings are automatically used as
Preferred
connection, see Messages,
p. 45.
Setup
New access point
OptionsKNew access point
Use default settings
If you want to use default entries.
Use existing settings
If you want to change an existing
entry to create a new access point,
select it from the list.
There are three types of connection
available:
GSM data call
Data transmission rate up to 14.4 kbps.
To configure this access point:
•
Connection
•
Data
bearer:
•
Access point
•
User
name: from provider if required
•
Prompt
password: choose Yes if you
want to enter it at every logon
• Password: from provider if required
• Authentication: normal/Secure
•
Gateway IP
• Homepage: address of WAP service or
multimedia messaging center
•
Session
mode: e.g. Permanent
•
Connection
•
Data call
type: analog, ISDN v.110, ISDN
v. 120
•
Maximum data
14400,19200,28800
name: your choice
GSM data
name: from provider
address: from provider
security: from provider
speed: automatic, 9600,