Siemens SX1 User Manual page 100

SX1 K1 am-en, A31008-H6500-A5-1-7619 (29. July 2003, 19:33)
100
Question Possible causes
Message cannot Some service providers do
be sent. not support this service.
Phone number of the
service center is not set or
is wrong.
SIM card contract does not
support this service.
Service center overloaded. Repeat message.
No selection from
addresses possible.
Addressee does not have
a compatible phone.
Messages cannot be Phone memory full.
received
Wrong settings.
No Internet access Wrong WAP profile set
possible. or settings wrong,
incomplete.
PIN error/ Three wrong entries.
PIN2 error.
Phone code error. Three wrong entries.
Service provider No authorization for this
code error. service.
No fax possible. Incorrect settings in
the PC.
No authorization for this
service.
Charge counter does Charge pulse not
not work. transmitted.
Damage
Severe shock. Remove battery and SIM and insert them again. Do not dismantle phone!
Phone became wet. Remove battery and SIM card. Dry immediately with cloth, do not heat. Dry
connector contacts thoroughly. Stand unit upright in an air current. Do not dismantle
phone!
Reset settings to the factory default:
Questions & Answers
Possible solution
Check with your service provider.
Set message center (p. 44).
Contact your service provider.
Entry has no phone number (p. 28).
Check, if the receiver has a compatible phone.
Delete stored messages or images.
Check settings for specific message type.
Check settings (p. 51), if necessary consult your service
provider.
Enter the PUK (MASTER PIN) provided with the SIM
card according to the instructions. If the PUK (MASTER
PIN) has been lost, contact your service provider.
Contact Siemens Service (p. 101).
Contact your service provider.
Check settings.
Contact your service provider.
Contact your service provider.
*
# 7780 #. Enter security code, see p. 19.