Flash-To-Pass - Chrysler pacifica hybrid 2017 Owner's Manual

automatically switches from high beams to low beams
until the approaching vehicle is out of view.
NOTE: Broken, muddy, or obstructed headlights and tail-
lights of vehicles in the field of view will cause headlights
to remain on longer (closer to the vehicle). Also, dirt, film
and other obstructions on the windshield or camera lens
will cause the system to function improperly.
To Activate
1. Select "Automatic High Beams — ON" through the
Uconnect system. Refer to Uconnect Settings" in "Mul-
timedia" for further information.
2. Rotate the headlight switch clockwise to the AUTO
position.
3. Push the multifunction lever away from you to switch
the headlights to the high beam position. Refer to
"Multifunction Lever" in this section for further infor-
mation.
NOTE: This system will not activate until the vehicle is at,
or above 16 mph (25 km/h).
GETTING TO KNOW YOUR VEHICLE 95
To Deactivate
Perform either of the following steps to deactivate the
Automatic High Beam system.
1. Select "Automatic High Beams — OFF" through the
Uconnect System. Refer to "Uconnect Settings" in "Mul-
timedia" for further information.
2. Pull the multifunction lever toward you to switch the
headlights from the high beam to the low beam position.
3. Rotate the headlight switch counterclockwise from the
AUTO to the on position.
NOTE: Once active, the Automatic High Beam system will
stop functioning below 12 mph (20 km/h).

Flash-To-Pass

You can signal another vehicle with your headlights by
lightly pulling the multifunction lever toward you. This
will cause the headlights to turn on at high beam and
remain on until the lever is released.
3