Battery Saver On/Battery Saver Mode Message - Electrical Load Reduction Actions - If Equipped - Chrysler pacifica hybrid 2017 Owner's Manual

166 GETTING TO KNOW YOUR INSTRUMENT PANEL
• Defaults are highlighted in BOLD.
• Unique Hybrid Features Highlighted in Italic font .
• Option that may be setup as Default and Hybrid Fea-
tures Highlighted in BOLD Italic font.
Speed Warning — If Equipped
Push and release the up or down arrow button until Speed
Warning is highlighted in the instrument cluster display.
Push and release the OK button to enter speed warning.
Use the up or down arrow button to turn the speed
warning ON or OFF, then push and release the OK button
to confirm the selection. If the ON status is selected, use the
up or down arrow button to set the desired speed, then
push the OK button to set the speed for the speed warning.
A speed warning telltale will illuminate in the instrument
cluster, with a number matching the set speed, with a pop
up message to inform the driver that the speed warning
has been set to the desired speed. Each time the set speed
is exceeded, an audible chime will sound for up to 10
seconds, or until the speed is no longer exceeded. The
telltale in the instrument cluster will also change from
white to yellow, and a pop up warning message will pop
up on the instrument cluster display.
NOTE: Speed Warning is unavailable while KeySense is in
use.
Battery Saver On/Battery Saver Mode Message —
Electrical Load Reduction Actions — If Equipped
The vehicle is equipped with an Intelligent Battery Sensor
(IBS) to perform additional monitoring of the electrical
system and status of the vehicle battery.
In cases when the IBS detects charging system failure, or
the vehicle battery conditions are deteriorating, electrical
load reduction actions will take place to extend the driving
time and distance of the vehicle. This is done by reducing
power to or turning off non-essential electrical loads.
Load reduction will be functional when the hybrid propul-
sion system is active. The vehicle may not be running
depending on the battery SOC and temperature. It will
display a message if there is a risk of battery depletion to
the point where the vehicle may stall due to lack of
electrical supply, or will not restart after the current drive
cycle.
When load reduction is activated, the message "Battery
Saver On" or "Battery Saver Mode" will appear in the
Instrument Cluster Display.