Flash-To-Pass; Automatic Headlights - Chrysler 300c Owner's Manual

20_LX_OM_ENA_GCC_t.book Page 40
40 GETTING TO KNOW YOUR VEHICLE
light and automatically switches from high
beams to low beams until the approaching
vehicle is out of view.
NOTE:
The Automatic High Beam Headlamp Control

can be turned on or off by selecting "ON"
under "Auto High Beam" within your
Uconnect settings, as well as turning the
headlight switch to the AUTO position. Refer
to "Uconnect Settings" in "Multimedia" for
further information.
Broken, muddy, or obstructed headlights and

taillights of vehicles in the field of view will
cause headlights to remain on longer (closer
to the vehicle). Also, dirt, film, and other
obstructions on the windshield or camera
lens will cause the system to function improp-
erly.
If the windshield is replaced, the camera must
be re-aimed to ensure proper performance. See
a local authorized dealer.
To Activate
1. Turn the headlight switch to the AUTO head-
light position.
2. Push the multifunction lever away from you
(toward front of vehicle) to engage the high
beam mode.
NOTE:
This system will not activate until the vehicle is
at or above 15 mph (24 km/h).
To Deactivate
1. Pull the multifunction lever toward you (or
rearward in vehicle) to manually deactivate
the system (normal operation of low
beams).
2. Push back on the multifunction lever to
reactivate the system.
The Automatic High Beams can also be deacti-
vated through the Uconnect system. Refer to
"Uconnect Settings" in "Multimedia" for further
information.

Flash-To-Pass

You can signal another vehicle with your head-
lights by lightly pulling the multifunction lever
toward you. This will cause the high beam head-
lights to turn on, and remain on, until the lever
is released.

Automatic Headlights

This system automatically turns the headlights
on or off according to ambient light levels. To
turn the system on, rotate the headlight switch
counterclockwise to the AUTO position. When
the system is on, the headlight time delay
feature is also on. This means the headlights
will stay on for up to 90 seconds after you place
the ignition into the OFF position. The headlight
time delay can be programmed 0/30/60/90
seconds.
Refer to "Uconnect Settings" in "Multimedia"
for further information.
To turn the automatic system off, move the
headlight switch out of the AUTO position.
NOTE:
The engine must be running before the head-
lights will come on in the automatic mode.