Procedure; Description Of The Exercise - GE Multilin W650 Instruction Manual

12.3 EXAMPLE 3: PROCEDURE TO SET AN OPERATION
12.3EXAMPLE 3: PROCEDURE TO SET AN OPERATION
12
This simple operation describes how to program and set an operation command on the W650 relay. In the present case
the operation is:
To configure some W650 output contact to be operated since the front of the relay.
To set some LED to show the operation of the output contact (while being closed).
To close a W650 output contact using a front key pushbutton.
To reset the output contact and LED using another front key pushbutton.
Set the following values:
Under
SETPOINT ⇓ CONTROL ELEMENTS ⇒ INPUTS/OUTPUTS ⇒ BOARD F
* This setting is non-relevant since it applies only when "pulse" type is chosen
Under
SETPOINT ⇓ RELAY CONFIGURATION ⇒ OUTPUTS
SELECT
Contact Output Operate 00 (Board F)
Contact Output Reset 00 (Board F)
Under
SETPOINT ⇓ RELAY CONFIGURATION ⇒ LEDS
12-8
NAME
Output Logic_00_00
Output Type_00_00
Pulse Output Time
SELECT NAME
Close Contact_00_00
Led 14
W650 Wind Generator Protection System
12 APPLICATION EXAMPLES

12.3.1 DESCRIPTION OF THE EXERCISE

VALUE
Positive
Latch
10000ms *
NAME
C_Output Oper_00_00
C_Output Reset_00_00
SOURCE
C_Output_00_00

12.3.2 PROCEDURE

SOURCE
Operation_bit000
Operation_bit001
GEK-113032A