Table of Contents
Advertisement
10 BOOTCODE AND FIRMWARE UPGRADE
10.1 INTRODUCTION
Go to the Control Panel of the computer and select the Network option (the name of this option may depend on the PC
boot code).
Figure 10–2: NETWORK IN CONTROL PANEL
In Network, enter in Protocols, select TCP/IP protocol and click on Properties.
Figure 10–3: TCP/IP PROPERTIES
In the IP address tab, select Advanced... (Figure 10–3:) and add a new address in the PC that corresponds to the same
LAN pattern that the relay has (in the example bellow 192.168.37.54).
10
GEK-113032A
W650 Wind Generator Protection System
10-3
Advertisement
Table of Contents
