Table of Contents
Advertisement
10.2 BOOT CODE UPGRADE
10 BOOTCODE AND FIRMWARE UPGRADE
Figure 10–13: ERASING FLASH MEMORY
Once the memory has been erased and the files upgraded in the relay, the parameters for the Ethernet communications
must be set (Figure 10–14:). The requested values are the IP address and the gateway
Figure 10–14: ETHERNET PARAMETERS
These values should match the LAN structure in which the relay will be connected.
The gateway must be the one used in the LAN structure connecting the relay. The relay IP address should have the first
three octets corresponding with the Gateway and the last octet must be a free IP address reserved to the relay to avoid
possible collisions with other devices.
After assigning the Ethernet parameters, the upgrade of the boot code has been completed successfully (Figure 10–15:).
Figure 10–15: BOOT PROGRAM UPGRADED
10
After boot code upgrade, the equipment firmware must also be upgraded (Section 10.3).
10-8
W650 Wind Generator Protection System
GEK-113032A
Advertisement
Table of Contents
