Table of Contents
Advertisement
5.5 CONTROL ELEMENTS
5.5CONTROL ELEMENTS
The W650 incorporates the following control elements:
Setting Group
Underfrequency
Overfrequency
Autoreclose (79)
Breaker Failure (50BF)
VT Fuse Failure
Note: for all control elements related to the breaker, it must be considered that all operations will be performed considering
the status of the switchgear configured as breaker. In Setpoint > Relay Configuration > Switchgear up to 16 switchgear
elements can be configured to operate and be monitored, but only one of them can be configured as a breaker, for
monitoring, number of openings and closings counters, (KI)
The settings used for setting table management are located in Setpoint >Control Elements >Setting Group:
Table 5–68: SETTING GROUP SETTINGS
SETPOINT > CONTROL ELEMENTS > SETTING GROUP
SETTING DESCRIPTION
5
Setting Grouping Permission
Active Group
Snapshot Event generation
The snapshot event setting enables or disables the snapshot event generation for this element.
For more detailed information go to section 5.4.1
Note: SETTING GROUP 4 includes only protection elements 29P, 59P, 81U and 81O. Please refer to Table 5–28:
DISTRIBUTION OF PROTECTION ELEMENTS.
5-74
2
t.
NAME
DEFAULT
VALUE
Function
DISABLED
Active Group
GROUP 1
Snapshot Events
ENABLED
W650 Wind Generator Protection System
5.5.1 SETTING GROUP
STEP RANGE
N/A
[DISABLED – ENABLED]
N/A
[GROUP 1 – GROUP 2 – GROUP 3 – GROUP 4]
N/A
[DISABLED – ENABLED]
5 SETTINGS
GEK-113032A
Advertisement
Table of Contents
