Transmitter board installation
Caution! Turn off the power and air supply before starting the installation.
Maintenance and repairs on PMV
D3 units with hazardous area
approvals should only be made
by authorized staff.
• Remove the cover, indicator and inner
cover according to the description on page
37.
• Check that both spacers C are installed.
• Carefully mount the PCB in its position. The
pins D should fit in the connector and the
positioner's motherboard. Make sure that
the feedback PCB is properly connected.
• Secure the PCB with the enclosed screws
E.
• Install the cam asssembly B on the shaft
and push it down to its position. If the
board has microswitches, be careful not
to damage the levers.
PMV D3 Digital Positioner
B
39
FCD PMENIM0001-06 A5 09/16
C
C
D
E