Flowserve PMV D3 User Instructions page 29

TRVL range
0%=0.0%
Set 0%
100%=100.0%
Set 100%
Trvl ctrl
Set low
Set high
Values
Passcodes
Full menu
Write prot
Expert
Fact set
Numbers between 0000 and 9999 can be
used as passcodes. 0 = no passcode required.
Appearance
Language
Setting end positions
Select Out of Service.
Set percentage value
for desired end position
(e.g. 3%).
Select In Service.
Connect calibrator.
Move forward to desired
end position (0%) and
press OK.
Select Out of Service.
Set percentage value for
desired end position
(e.g. 97%).
Select In Service.
Connect calibrator. Move
forward to desired end
position (100%) and
press OK.
Behavior at set end
position
Choose between Free (go
to mechanical stop),
Limit (stop at set end
position), and Cut off (go
directly to mechanical
stop at set end position).
Similar to Set low.
Select position for Cut off
and Limit at the
respective end positions.
Setting passcodes for
various functions
Passcode for access to
full menu.
Passcode for removing
write protect.
Passcode for access to
Expert menu (TUNING).
Passcode to return to
default values applicable
when positioner was
delivered.
On display
Select menu language.
PMV D3 Digital Positioner
Units
Def. Display
Start menu
Orient
Par mode
Devicedata
HW rew
SW rew
Capability
HART
Profibus PA/DP
Status
Device ID
Address
Tag
Descriptor
Date
Failsafe
Foundation Fieldbus
Device ID
Nod address
TAG–PD_TAG
Descriptor
Date
Sim jumper
29
FCD PMENIM0001-06 A5 09/16
Select units.
Select value(s) to be
displayed during service.
The display reverts to
this value 10 minutes
after any change is made.
Start in Basic menu or
Full menu.
Orientation of text on
display.
Display of control para-
meters such as P, I, D or
K, Ti, Td.
General parameters.
Menu with HART para-
meters. Only amendable
with HART communi-
cator. It is possible to read
from display.
Indicates present status
Serial number
1-126
Allotted ID
ID description
SW release date
Value = preset pos
Time = Set time +10sec=
time before movement
Valve act = failsafe
(preset pos) or last value
(present pos)
Alarm out= On/Off
Serial number
Address on the bus
provided by the DCS
system
Name provided by the
DCS system
PMV D3 positioner
SW release date
Simulate jumper, FF
simulation functionality
activated = ON