Installing and Configuring the Director
LAN-Connect the Director
Use these steps to connect the rack-mounted director to the Ethernet LAN
segment.
1. Connect one end of an Ethernet cable to the RJ-45 connector on each CTP
1
2
Figure 21: LAN-connect the director
2. Connect the remaining end of each Ethernet cable to the LAN as directed by
Note:
interface. Attach the Ethernet LAN segment to an Internet connection.
60
card, as shown in
Figure
Remote workstation
Ethernet hub or switch (customer
supplied)
the customer's network administrator.
If an HAFM appliance is not available, use the Embedded Web Server (EWS)
21.
HAFM appliance (laptop or
3
rack-mount)
Director 2/140
4
Director 2/140 Installation Guide