Configuring Director Management Style; Configure Identification Dialog Box - HP StorageWorks Director 2/140 Installation Manual

Follow these steps to configure the director identification:
1. At the Hardware View page, choose Configure > Identification. The
Figure 27: Configure Identification dialog box
2. Enter a director name of 24 or fewer alphanumeric characters in the Name
3. If the director is installed on a public LAN, the name should reflect the
4. Enter a director description of 255 or fewer alphanumeric characters in the
5. Enter the director's physical location (255 or fewer alphanumeric characters)
6. Enter the name of a contact person (255 or fewer alphanumeric characters) in
7. Click Set Name as Nickname to add a check mark to the check box if you
8. Click Activate to save the information and close the dialog box.

Configuring Director Management Style

Note:
director back online after you change this value.
Perform this procedure to set the director to open systems or FICON management
style. This setting only affects the management style used to manage the director;
it does not affect port operation. OSI devices can communicate with each other if
Director 2/140 Installation Guide
Configure Identification dialog box displays, as shown in
field. Each director should be configured with a unique name.
director's Ethernet network DNS host name. For example, if the DNS host
name is SAN140.hp.com, the name entered in this dialog box is SAN140.
Description field.
in the Location field.
the Contact field.
want to use the name in the Name field as a nickname for the director WWN.
The nickname displays instead of the WWN in Element Manager views.
To change this value, you must first set the director offline. Be sure to set the
Installing and Configuring the Director
Figure 27.
69