Continuous Recording; Figure 34: Disturbance Recorder - Continuous Recording Configuration Section - GE RPV311 Technical Manual

Chapter 4 – Configuration
11.2

Continuous Recording

Figure 34: Disturbance recorder – continuous recording configuration section
80
C The T field contains all the thresholds created. The logic equation uses
RIGGER LOGIC
AND and OR logic operators over previously defined thresholds. Initially, all preset
thresholds are displayed as implicit OR operators, one per line.
To enable thresholds individually, click on the threshold and select E
To disable discarded thresholds individually, click on the threshold and select D
To break or remove complex thresholds, click on the threshold and select C
To create equations with AND operators, follow the procedures below:
 Click on the threshold and select C
Click on the threshold to which is desired to add the previously selected

threshold and then select the threshold to be added.
D Selecting the R
ECEIVE
check box enables these features. It allows the start of the recording of an
exceeded threshold by Ethernet cross-trigger.
E The <S
ELECT QUANTITY
triggered disturbance records. If the quantities are not manually selected, the
record will consist of all the quantities available for measurement.
In this section, shown in
continuous recorder.
UT LAST
E -
THERNET CROSS TRIGGER
> button allows user to select the derived quantity of
Figure 34, it is possible to configure the equipment's
;
NABLE
;
or S E
END THERNET CROSS
RPV311-TM-EN-7
RPV311
;
ISABLE
;
UT LAST
-
TRIGGER