Auto Upload; Figure 19: Record Management Configuration Section - GE RPV311 Technical Manual

Chapter 4 – Configuration
2.9

Auto Upload

2.9.1 Records
60

Figure 19: Record management configuration section

A Selecting the A
UTO ERASE
capacity exceeds 90%.
B The E scroll box allows user to choose a type of record (fault, disturbance,
RASE ALL
steady-state and SOE) to be removed.
C The <E > button allows user to erase all the records on the list.
XECUTE
For details about the memory capacity of each record type, see Chapter 6: Records.
It is possible to send a record to two different servers. In the configuration interface it
is possible to configure the IP address of each destination server and the type of
record which will be sent. When a new record is generated and the record type is
enabled for auto upload, it is automatically transmitted to the servers.
If at the upload time the server is not available or the network is unreadable, the
record is not retransmitted. In this case, the record will be transmitted only through
the automatic scanning by the server.
The automatic upload of records is a process in which the records are transferred to
the server in advance. To ensure that all the records are stored in the server, it is
necessary that the server perform the scanning process periodically. The records
that have already been transmitted to the server are not retransmitted.
In the section shown in
preset destination.
check box, erases older record automatically if memory
Figure 20, it is possible to automatically upload records to a
RPV311
RPV311-TM-EN-7