Polling And Refresh; Figure 97: Rpv Manager Twfl Methods - GE RPV311 Technical Manual

Chapter 13 – RPV Manager
2.4

Polling and Refresh

2.4.1 Refresh
RPV311-TM-EN-7
the correct time stamp for the fault. As the time window to track the fault waveform
in narrow down using this method, various system noises are eliminated from the
calculations increasing significantly the chances to automatically find the fault.

Figure 97: RPV Manager TWFL methods

The equipment refresh option performs the following actions:

Update of the list of records on the home screen;

Updating the status of the equipment;

Update of Alarms (Alarms tab);

Verification of alarms for sending e-mail/fax;

Check the settings (local and remote).
This refresh may occur in the following situations

"Refresh" option from the equipment menu, access by right clicking on the
substations equipment tree in the System Monitor. This option will update

the data of the selected equipment;

"Refresh All Devices", access through the File menu. This option will update
all registered equipment;

"Auto Refresh". This option will update only the information of configured
equipment.
To configure the Auto Refresh:
1. For each device the the box Enable Auto Refresh on the Settings>Device
menu;
2. To set the update interval change the field "Auto Refresh Interval " on the
Configuration>Polling menu;
3. To activate or deactivate the Auto Refresh, access the Polling menu and
choose between Manual or Auto options;
RPV311
201