Cross-Trigger; Fault Recorder; Trigger'd Recording; Figure 30: Adding And Editing A Dc Threshold - GE RPV311 Technical Manual

Chapter 4 – Configuration
9

Cross-Trigger

10

Fault Recorder

10.1

Trigger'd Recording

76

Figure 30: Adding and editing a DC threshold

A The <A > button allows user to apply the hold time or the hysteresis for all
PPLY ALL
threshold.
B The <R > button allows user to delete the threshold.
EMOVE
The cross-trigger is performed through an Ethernet broadcast UDP message sent
whenever the device triggers, then all the RPV311 within the network with the cross-
trigger enabled will receive the message and trigger as well.
The RPV311 allows user to register triggered and continuous fault recorder.
In this section, shown in
triggered recorder.
Figure 31, it is possible to configure the equipment's fault
RPV311
RPV311-TM-EN-7