Sc7Xx: Peripherals - Ricoh M022 Service Manual

SC7xx: Peripherals

No. Type
Finisher jogger motor error
The jogger fences move out of the home position but the HP sensor output does not
change within the specified number of pulses.
The 1st failure issues an original jam message, and the 2nd failure issues this SC
code.
721 B
• Jogger HP sensor disconnected, defective
• Jogger motor disconnected, defective
• Jogger motor overloaded due to obstruction
• Finisher main board and jogger motor
1. Check the connections and cables for the components mentioned above.
2. Check for blockages in the jogger motor mechanism.
3. Replace the jogger HP sensor and/or jogger motor.
4. Replace the finisher main board.
No. Type
Finisher exit guide plate motor error (with the side tray installed)
After moving away from the guide plate position sensor, the exit guide is not
detected at the home position within the prescribed time. The 1st detection failure
issues a jam error, and the 2nd failure issues this SC code.
• Guide plate motor disconnected, defective
• Guide plate motor overloaded due to obstruction
725 B
• Guide plate position sensor disconnected, defective
1. Check the connections and cables for the components mentioned above.
2. Check for blockages in the guide plate motor mechanism.
3. Replace the guide plate position sensor and/or guide plate motor
4. Replace the finisher main board.
CÓPIA NÃO CONTROLADA
Details (Symptom, Possible Cause, Troubleshooting Procedures)
Details (Symptom, Possible Cause, Troubleshooting Procedures)
CÓPIA NÃO CONTROLADA
SC Tables
6
683