Table 3-5 Internet Access Setup Menu Fields - ZyXEL Communications Prestige 202 User Manual

Prestige 202 ISDN Router
FIELD
ISP's Name
Pri Phone and Sec Phone #
My Login
My Password
My WAN IP Addr
NAT
Address Mapping Set
Telco options:
Multilink
Idle Timeout
At this point, the SMT will ask if you wish to test the Internet connection. If you select Yes, your
Prestige will call the ISP to test the Internet connection. If the test fails, note the error message that
you receive on the screen and take the appropriate troubleshooting steps.
3-12

Table 3-5 Internet Access Setup Menu Fields

Enter the name of your Internet Service Provider, e.g., myISP. This
information is for identification purposes only.
Both the Primary and the Secondary Phone number refer to the number
that the Prestige dials to connect to the ISP.
Enter the login name given to you by your ISP.
Enter the password associated with the login name above.
Some implementations, especially the UNIX derivatives, require the
WAN link to have a separate IP network number from the LAN and each
end must have a unique address within the WAN network number. If
this is the case, enter the IP address assigned to the WAN port of your
Prestige.
NOTE: This is the address assigned to your local Prestige WAN, not the
remote router. If the remote router is a Prestige, then this entry
determines the local Prestige Rem IP Addr in Menu 11.1.
Choose from None, Full Feature or SUA Only. See ahead for a full
discussion of this new feature.
A NAT Server Set is a list of LAN side servers mapped to external ports
(similar to the old SUA menu). You may enter any server set number up
to 10, but the first one is used for SUA only.
Transfer This field specifies the type of connection between the Prestige and this
Type remote node. Select 64K, or Leased.
The Prestige uses the PPP Multilink Protocol (PPP/MP) to bundle
multiple links in a single connection to boost the effective throughput
between two nodes. This option is only available if the transfer type is
64K. Options for this field are: Off/BOD/Always.
This value specifies the number of idle seconds that elapses before the
remote node is automatically disconnected. Idle seconds is the period of
time when no data is transmitted from your Prestige. Administrative
packets such as RIP are not counted as data. This option only applies
when the Prestige initiates the call.
DESCRIPTION
Internet Access