Filename Conventions; Figure 12-10 Display For A Failed Authentication - ZyXEL Communications Prestige 202 User Manual

Prestige 202 ISDN Router
This figure shows an example where authentication failed.
Start dialing for node <1>
### Hit any key to continue. ###
Dialing chan<2> phone<last 9-digit>:23456
Call CONNECT speed<64000> chan<2> prot<1>
LCP up
CHAP send response
***Login to remote failed. Check name/passwd.
Receive Terminal REQ
IPCP down
Line Down chan<2>

12.4 Filename Conventions

The configuration file (sometimes called the romfile or romfile-0) contains the settings in the
menus such as password, DHCP Setup defaults, TCP/IP Setup defaults, etc. The external (i.e., not
on the Prestige) configuration filename is usually the router model name with a *.rom extension,
e.g., P202.rom. The ZyNOS firmware file (sometimes referred to as the "ras" file) is the file that
contains the ZyXEL Network Operating System firmware and the external firmware file is
usually called the router model name with a *.bin extension, e.g., P202.bin. Rename the
configuration filename to "rom-0" and the firmware filename to "ras" when transferring files to
the Prestige (i.e., the internal filenames on the Prestige). Renaming the files is not necessary when
you transfer files to the Prestige using the XMODEM protocol.
The following table is a summary. Please note that the internal filename refers to the filename on
the Prestige and the external filename refers to the filename not on the Prestige, i.e., on your
workstation, local network, or ftp site and so the name (but not the extension) will vary. The AT
command is the command you enter after you press "Y" when prompted in the SMT menu to go
into debug mode. After uploading the new firmware see the ZyNOS F/W Version field in
Menu 24.2.1 to check if you have uploaded the correct firmware version.
12-12

Figure 12-10 Display for a Failed Authentication

System Maintenance