Configuring Networking Parameters - Hughes 9201 User Manual

C N P
ONFIGURING ETWORKING ARAMETERS
To configure networking parameters from LaunchPad, select the Network Mode drop down
menu from the terminal tab. This was updated in LaunchPad release 4.0.4 to add Relay Mode
support.
You must restart the UT for any changes on this page to take effect.
If you change the UT IP address, you should disconnect and reconnect the TE to allow it to clear
and update its IP configuration. LaunchPad will lose its connection. When you restart LaunchPad
you must select the "Connect Manually" option and enter the new UT IP address.
84
BGAN 9201 User Manual