Using The Bgan Launchpad - Hughes 9201 User Manual

U BGAN L
SING THE AUNCH
Start the BGAN LaunchPad on your computer. The Setup Screen is shown below in Pointing
Mode.
1. Confirm your nearest city in the information box to the left of the map. You can change it by
clicking on the map at your current location or click on nearest city and then select from the
list. Your location will be used to determine the recommended antenna angle and compass
direction to any visible satellites. LaunchPad gives the compass direction in both degrees
and direction, the compass shows direction as North, South, East and West, with 10 degree
divisions.
2. Correctly point the terminal using one of the methods described below.
3. When you are ready to register with the network, click on Register with Network now. Refer to
Registering with the Network. Note: You can also register with the network by pressing the
"Audio" button on the terminal for 3-4 seconds. Alternatively, if you have an ISDN handset
connected to the terminal, you can exit pointing and register by pressing the #1# keys.
Once the GPS light goes out, the terminal is registered with the network.
4. When you have successfully registered with the network, your position will be displayed on
the map, but only if allowed by local regulations.
5. You can now make phone calls or set up data connections as described later.
BGAN 9201 User Manual
P
AD
15