Table of Contents
Advertisement
If you want to setup additional ranges of addresses, please follow the same instructions as
above. Note: You cannot overlap the IP address ranges. If you do, an error will pop-up telling
you that you have an overlap region. Check all of the ranges for overlaps and try again.
When you are finished, click on "Apply" and you should see a message saying "Operation
Successful".
ACA settings for TEs using DHCP assigned IP address: This option allows you to set up the UT for
dynamic background ACA. This means that any device connected to the UT, will automatically
receive a background PDP context.
To activate this feature, select the "On" radio button under ACA settings for TEs using DHCP
assigned IP address and click on "Apply". To have the context only be activated when the TE
sends data, select "DA".
To see if the context has been setup properly, click on the PDP Contexts page and this will show
you all the contexts that have been setup (active or inactive). See screen shot below.
45
BGAN 9201 User Manual
Advertisement
Table of Contents
