Using The Bgan Terminal Signal Quality Leds; Using The Audio Buzzer - Hughes 9201 User Manual

U BGAN T
SING THE ERMINAL
To point the antenna using the LEDs:
1. Set the angle and position of the BGAN terminal using the compass and the graduated
scale. If you do not know the angle and position to set the terminal to, use the BGAN
LaunchPad pointing screen.
Note the Pointing indicator LEDs as you point the terminal to obtain the maximum possible
signal quality.
2. The following table shows the colors of the pointing LEDs from the weakest to strongest, as
you point the terminal to the BGAN satellite
3. When you have finished pointing the terminal, you are ready to register with the network. Go
to the next section Registering with the Network.
U A B
SING THE UDIO UZZER
You can also monitor the signal quality using the audio buzzer. By default the audio buzzer is
switched off. To use the buzzer when the terminal is in pointing mode:
1. Press the audio button to turn the buzzer on.
2. Monitor the signal quality using the buzzer. The higher the pitch and the shorter the interval
between tones, the stronger the signal.
3. When you have finished pointing the terminal, you are ready to register with the network. .
Note: You can register with the network by pressing the "Audio" button on the terminal for 3-
16
S LED
IGNAL QUALITY S
BGAN 9201 User Manual