Table of Contents
Advertisement
To check the power steering fluid level, be
sure the ignition is "OFF", then check to make
certain that the power steering fluid level is
between the "MAX" and "MIN" level markings
on the fluid reservoir.
NOTE:
Grinding noise from power steering pump
may be heard immediately after the engine
is started in extremely cold condition
(below -4°F). If the noise stops during warm
up, there is no abnormal function in the
system. This is due to a power steering
fluid characteristic in extremely cold con-
ditions.
FLUID RECOMMENDATION
Only automatic transmission fluid meeting the
specification of PSF-3 or Dexron 2 should be
used in the power steering system.
OWNER MAINTENANCE
SG230B1-E
POWER STEERING HOSES
Power steering hoses should be checked for
damage, deterioration and leakage at each ser-
vice.
G350B01FC-GAT
BLEEDING THE FUEL SYSTEM
(Diesel engine)
The fuel system should be bled to remove air
as described in the illustration if the fuel supply
is exhausted during travel, when the fuel filter
is replaced, or if the vehicle is not used for a
long time.
1. Remove the air cap with pushing the but-
ton.
Air pipe
2. Pump the hand pump until there are no
more bubbles in the fuel coming out of the
air pipe. When doing this, place a cloth
around the air pipe to prevent the escaping
fuel from spewing about.
3. Replace the air cap when there are no
more bubbles in the fuel.
4. Continue pumping until the hand pump
becomes stiff.
5. Finally, check to be sure that there is no
G350A01FC
leakage of fuel.
If in doubt, consult your nearest Hyundai
authorised repairer.
WARNING:
o Do not smoke or have any other open
flame near the vehicle while bleeding
the fuel system.
o Be sure to carefully wipe away any
water drained out in this manner, be-
cause the fuel mixed in the water might
be ignited and result in a fire.
G350B01FC
6-23
Advertisement
Table of Contents
