Table of Contents
Advertisement
SB220D1-E
HIGH AND LOW BEAM
To turn on the headlight high beams, push the
lever forward (away from you). For low beams,
pull the lever back (toward you). The appropri-
ate headlight beam indicator light will come on
at the same time.
SB220E1-E
HEADLIGHT FLASH
B340E01FC-D
The headlights may be flashed by pulling the
turn signal switch lever towards the steering
wheel. The headlights will be extinguished
when the switch is released.
CONTROLS AND EQUIPMENT
SB230A1-E
WINDSCREEN WIPER/WASHER
SWITCH
(1)
(2)
(3)
B350A01O-D
The windscreen wiper switch, dependent upon
model, has three operating positions.
1. Intermittent wiper operation.
(Not all models)
2. Low speed operation.
3. High speed operation.
NOTE:
To prevent damage to the wiper system,
do not attempt to wipe away heavy accu-
mulations of snow or ice.
Accumulated snow and ice should be
removed manually. If there is only a light
layer of snow or ice, operate the heater in
the defrost mode to melt the snow or ice
before using the wiper.
B350B01O-EAT
Windscreen Washer Operation
B350B01O.DAG
To use the windscreen washer, pull the wiper/
washer lever toward the steering wheel. When
the washer lever is operated, the wipers auto-
matically make two passes across the
windscreen. The washer continues to operate
until the lever is released.
NOTE:
o Do not operate the washer more than 15
seconds at a time or when the fluid
reservoir is empty.
o In icy or freezing weather, be sure the
wiper blades are not frozen to the glass
prior to operating the wipers.
o In areas where water freezes in winter,
use windscreen washer antifreeze.
1- 39
Advertisement
Table of Contents
