Snow Tyres; Tyre Chains; Tyre Rotation; Tyre Balancing - Hyundai Matrix Owner's Manual

Hide thumbs Also See for Matrix:
Table of Contents

Advertisement

Tyre pressures should be increased by 3 psi
when the vehicle is driven fully laden or under
conditions of sustained high speed motoring.
SI030A2-E

SNOW TYRES

If it is desired to fit snow tyres to the vehicle,
it must be ascertained that the original size
and load carrying capacity are met by the
replacement tyres. When using snow tyres,
the vehicle should not be driven at speeds in
excess of 60 MPH.
SI040A1-E

TYRE CHAINS

Tyre chains, when included, should be in-
stalled on the front wheels. Be sure that the
chains are the proper size and that they are
installed
in
accordance
with
manufacturer's instructions.
To minimise tyre and chain wear, do not
continue to use tyre chains when they are no
longer needed.
CAUTION:
When driving on roads covered with snow
or ice, drive at less than 20 mph (30 km/h).
8-2
CONSUMER INFORMATION
I060A01FC-EAT

TYRE ROTATION

Spare tyre
The tyre wear characteristics will vary be-
tween each tyre dependant upon the condi-
tions of use. It is normal for the front tyres to
wear more rapidly than those fitted to the rear
of the vehicle and therefore tyre rotation will
the
provide a means of helping to ensure an even
wear rate across the tyre set. For vehicles
fitted with radial ply tyres, rotation should be
confined to front to rear tyre alternation. It is
not recommended that radial ply tyres be
rotated from side to side.
NOTE:
o Do not use the temporary spare tyre for
tyre rotation.
o Aluminium wheels which are not sup-
plied as Original Equipment should
not be mixed on the same vehicle with
the original steel wheels. However, it is
acceptable that the steel spare wheel
be used in conjunction with Original
Equipment aluminium wheels since the
offset of both wheels is compatible.
Radial and cross ply tyres should not
be mixed on the same vehicle.
HA1409
SI060A1-E

TYRE BALANCING

Incorrect tyre balance will cause steering
vibration and uneven tyre wear. The vehicle
tyres are balanced during production but may
need further balancing throughout the life of
the tyres.
It is recommended that the tyres be balanced
on the car for best results and that the tyres are
balanced whenever they have been removed
from the wheel for repair.

Advertisement

Table of Contents
loading

This manual is also suitable for:

Matrix 2005

Table of Contents